Page 1 of 1
syntax error
Posted: Tue Mar 08, 2016 9:40 pm
by mattandlaura
I have created a new eviews9 workfile and when I run a regression in the command line (nr c singd baht ringgit) and I receive a "syntax error." I have attached the eviews workfile. Can anyone help resolve this issue?
Re: syntax error
Posted: Tue Mar 08, 2016 9:57 pm
by EViews Gareth
What is the exact command you used?
Re: syntax error
Posted: Wed Mar 09, 2016 4:35 am
by mattandlaura
The exact command is:
nr c sing baht ringgit
Re: syntax error
Posted: Wed Mar 09, 2016 4:39 am
by mattandlaura
Sorry about that, the command is:
nr c singd baht ringgit
Re: syntax error
Posted: Wed Mar 09, 2016 5:12 am
by mattandlaura
I found the issue, in the command prompt, i did not use the method, so it should have been
ls nr c singd ringgit baht
for the least square method, sorry about that.