How to wirte the output of ARMA(p,q)?

[mountop21]

I wanna run the following regression:
Yt=b1*Yt-1+b2*Yt-2+C1*resid(-1)+C2*resid(-2)+resid.
What should I write in EViews under LS method?
Should it be ...
Y AR(1) AR(2) MA(1) MA(2) ?
OR
Y Y(-1) Y(-2) MA(1) MA(2)?
OR
Ohters?

coz we cannot use Y Y(-1) Y(-2) RESID(-1) RESID(-2).

Thanks a lot.

[EViews Gareth]

Either of the first two, depending on what you mean by resid in:
Yt=b1*Yt-1+b2*Yt-2+C1*resid(-1)+C2*resid(-2)+resid

If I were a betting man, reading a strict interpretation of that equation, I'd say you want:
y y(-1) y(-2) ma(1) ma(2)

[mountop21]

Either of the first two, depending on what you mean by resid in:
Yt=b1*Yt-1+b2*Yt-2+C1*resid(-1)+C2*resid(-2)+resid

If I were a betting man, reading a strict interpretation of that equation, I'd say you want:
y y(-1) y(-2) ma(1) ma(2)

Thanks a lot.
But I am not sure whether MA(1) MA(2) are able to represent RESID(-1) RESID(-2). Will that be Ok?

[EViews Gareth]

Again, you have to define what resid is.

Write down algebraically what your specification is.