EViews.com

Posted: **Thu Jun 06, 2019 6:23 am**

Is there a way to loop over a particular number of rows in tabplace, instead of providing the numbers manually. Instead of

Code: Select all

	tabplace (tab_new, tab_old, "A14","A14","N14") 
	tabplace (tab_new, tab_old, "A15","A16","N16")

Something like

Code: Select all

	
	!j=14
	for !i=14 to 100  step+2
	%dest="A"+@str(!j)
	%source_a="A"+@str(!i)
	%source_b="N"+@str(!i)
	tabplace (tab_new, tab_old, %dest,%source_a,%source_b) 
	!j=!j+1
	next

Posted: **Thu Jun 06, 2019 7:58 am**

Yes - doing it the way you suggest will work.

Posted: **Thu Jun 06, 2019 11:58 am**

This was my test version - but if I would add a particular row number (not step 2) saved in an additional table (tab_row) the procedure did not work.

Code: Select all

  
  
    !j=14
    for !i=1 to 5
  	scalar row =@val(tab_row(!i))
  	!row =row
  
   for !i=14 to 100  step+2
   
   %dest="A"+@str(!j)
   %source_a="A"+@str(!row)
   %source_b="N"+@str(!row)
   tabplace (tab_new, tab_old, %dest,%source_a,%source_b)
   !j=!j+1
   next

Do you have any suggestions?

Posted: **Thu Jun 06, 2019 7:04 pm**

Hard to see what you're doing from that.

EViews.com

tabplace

tabplace

Re: tabplace

Re: tabplace

Re: tabplace