Page 1 of 1
Pagecopy
Posted: Fri Jun 19, 2015 3:56 am
by svilen
Command "pagecopy" is much faster when you copy all the objects from one page to another. Is it possible to use "pagecopy" between two existing workfiles?
Re: Pagecopy
Posted: Fri Jun 19, 2015 4:35 am
by EViews Gareth
Pageload?
Re: Pagecopy
Posted: Fri Jun 19, 2015 5:05 am
by svilen
Pageload is fine with EViews 9 but in EViews 8 (Apr 27 2015) it always loads all pages from workfile, not only the selected one.
I use:
Re: Pagecopy
Posted: Fri Jun 19, 2015 11:10 am
by EViews Gareth
Use EV9 then :)
Re: Pagecopy
Posted: Mon Jun 22, 2015 1:09 am
by svilen
Could you please fix it in EV8 as well?
Re: Pagecopy
Posted: Mon Jun 22, 2015 5:03 am
by EViews Gareth
Doubtful - it was a conscious feature added to 9