How enter I(1) in Panel ARDL Equation, then Bounds test?

For technical questions regarding estimation of single equations, systems, VARs, Factor analysis and State Space Models in EViews. General econometric questions and advice should go in the Econometric Discussions forum.

Moderators: EViews Gareth, EViews Moderator

Post Reply
econochoice
Posts: 13
Joined: Fri Jun 05, 2009 1:55 am

How enter I(1) in Panel ARDL Equation, then Bounds test?

Postby econochoice » Tue Dec 13, 2016 8:02 am

1. How can I use Bounds Test with Panel Data in Eviews 9.5 SV

2. How should I write an equation where some of my variables are I(1) and some I(0). I see Eviews automatically puts a 'D' with short run coefficients.
Top
EViews Gareth
Fe ddaethom, fe welon, fe amcangyfrifon
Posts: 13586
Joined: Tue Sep 16, 2008 5:38 pm

Re: How enter I(1) in Panel ARDL Equation, then Bounds test?

Postby EViews Gareth » Tue Dec 13, 2016 8:49 am

The bounds test is not supported in panel data.
Top
Post Reply

Return to “Estimation”

Who is online

Users browsing this forum: No registered users and 2 guests