For questions about EViews Add-ins available from the EViews Add-ins webpage. Note each add-in available on our webpage will have its own individual thread.
10 posts • Page 1 of 1
I can't because it contains confidential data. However, I have tried to use cancor in several different workfiles and with different groups and I always get the response that !COLS is not defined or is an illegal command, which seems to be a programming problem. Is that in fact an EVIEWS command? I can't find it in the command reference. Do you have workfiles in which cancor works? Maybe you could send one to me. Thanks.
If I run the following program to generate a workfile, then run the CanCor add-in, using GY and GX as the two groups, it works fine:
Code: Select all
create u 100
group gx x1 x2
group gy y1 y2
Who is online
Users browsing this forum: No registered users and 11 guests