How is the adjusted sample determined in EViews when I run a stepwise regression? I included the same set of variables in 2 different systems (computers)- using the selection method as forward and asked the system to select 3 variables. When I look into the results from them, I see that the sample adjusted is different in each of them. How is the adjusted sample determined by the software? Any help will be appreciated. Thanks in advance.
For technical questions regarding estimation of single equations, systems, VARs, Factor analysis and State Space Models in EViews. General econometric questions and advice should go in the Econometric Discussions forum.
2 posts • Page 1 of 1
Just knocks off NAs from the start and end.
Follow us on Twitter @IHSEViews
Who is online
Users browsing this forum: No registered users and 6 guests