Page 1 of 1

How to run a program from command window

Posted: Fri Nov 20, 2020 1:28 pm
by Arca
Our institute currently has eViews 11. I am revisiting eViews after about 5 years. I have text files of several programs that I had written myself 5 years ago. I used to copy/paste these in the command window and run them easily. Now I seem to have forgotten how to run a program after copy/pasting its text in the command window. (If I hit enter I get one line executed. If I save the program as a .prg file, it runs alright.) I will greatly appreciate help. Thanks.

Re: How to run a program from command window

Posted: Fri Nov 20, 2020 2:56 pm
by EViews Gareth
Paste it into a program, not the command window.

File->New->Program

Re: How to run a program from command window

Posted: Sat Nov 21, 2020 11:06 am
by Arca
Wonderful. Your prompt reply was very helpful. Thanks a lot.