command history in series
Moderators: EViews Gareth, EViews Jason, EViews Steve, EViews Moderator
-
- Posts: 5
- Joined: Tue Jun 05, 2018 10:26 am
command history in series
Dear forum, I manipulate some series several time in sequence. However, when I open the spreadsheet of the transformed series, I can only see the last three transformations in the label rows.Wwould it be possible to change the settings, so that I can see all transformation conducted? many thanks
-
- Fe ddaethom, fe welon, fe amcangyfrifon
- Posts: 13323
- Joined: Tue Sep 16, 2008 5:38 pm
Re: command history in series
I think the history is set to the last 6 changes, and that is hard coded - no way to change it.
Follow us on Twitter @IHSEViews
-
- Posts: 5
- Joined: Tue Jun 05, 2018 10:26 am
Re: command history in series
Are you sure about the number 6 for the transformations documented? Or could it be that the number of rows available for reporting transformations is set to 6 implying that potentially only 3 transformations are reported? Despite conducting quite a lot of transformations, I find in each series only the last three reported.
-
- EViews Developer
- Posts: 564
- Joined: Thu Apr 25, 2013 7:48 pm
Re: command history in series
Hello,
There is a limit of six lines of history information following the topmost "Last updated" entry. However, lengthy update expressions span two lines. In practice, you'll see between the last three to six changes made, but no more than six lines total.
There is a limit of six lines of history information following the topmost "Last updated" entry. However, lengthy update expressions span two lines. In practice, you'll see between the last three to six changes made, but no more than six lines total.
Who is online
Users browsing this forum: No registered users and 28 guests